Quantcast
RWD - 1993 wagon Timing belt tensioner

Volvo RWD 900 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 1/2018 900 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

1993 wagon Timing belt tensioner 900

The tensioner gets replaced as an assembly. Loosen the nut on the stud. Pry the roller against the spring and be prepared to stick a drill bit or small diameter philips screwdriver into a hole you'll see in the end of shaft when you pry the roller against the spring. Pry the assembly off the front of the block. The "pin" keeps the assembly together and you may need a large pair of pliers or a vice to squeeze the spring so you can release the pin and let the assembly come apart. Reverse the steps to install the spring on the new assembly and place the assembly (with the pin in place) onto the stud--taking note that there is a small locating pin on the back side that needs to fall into place. Re-install the nut and washer (locking them with the spring compressed) and continue with the belt installation. -- Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1993 wagon Timing belt tensioner [900]
posted by  Griff951  on Thu Apr 18 18:37 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts