Quantcast
RWD - Rear axle shaft

Volvo RWD 120-130 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 2/2018 120-130 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Rear axle shaft 120-130

There is supposed to be some end play with the spec being 0.0028"-0.0079".

You want to be closer to the minimum if a new bearing(s) are being installed.

After changing shims and tightening the bolts, I always give the ends of both axles a whack with a copper hammer to set the bearings and then I check the end play.




--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502
hiperformanceautoservice.com or oldvolvosonly.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Rear axle shaft [120-130]
posted by  DBS  on Thu Mar 14 19:10 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts