Quantcast
RWD - Some Volvo 240 Questions...

Volvo RWD 200 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 6/2019 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Some Volvo 240 Questions... 200 1990

In our '90 744, the rear seat bottom cushion holders were shaped like a turtle shell with a slot that went down as well as forward and rearwards.

If you pushed too hard on the seat, the holder went into the rear slot, holding the seat down.

You had to push the bottom of the seat cushion rearward about 1/2 inch to use the center slot to release the seat.

Push all you want, but it is the bottom of the wire frame in the seat that must move back the right amount, the top of the seat does not count, The picture of the seat with the jack, shows the jack set too high.

techs are educated on things like this, not supermen!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Some Volvo 240 Questions... [200][1990]
posted by  TheBrickTank  on Wed Feb 27 11:59 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts