Quantcast
RWD - strut nuts torqe

Volvo RWD 200 Forum

INDEX FOR 7/2019(CURRENT) INDEX FOR 12/2015 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

strut nuts torqe 200 1990

I cut up a 24 mm open end wrench and went to work with the MIG to make a "spanner" out of it - with enough offset/depth to reach down to the nut. And then the appropriate Allen wrench through the wrench open end to hold the insert shaft. As tight as you can get it while holding the shaft with a typical Allen wrench -- likely the 15-25 ft-lbs mentioned by the other poster.
--
82 242-6.2L; '17 Mazda3; '16 Crosstrek






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New strut nuts torqe [200][1990]
posted by  popdaddy  on Sat Feb 9 09:57 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts