Quantcast
RWD - Crankshaft Oil Seal Misaligned

Volvo RWD 200 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 3/2004 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

Crankshaft Oil Seal Misaligned 200 1980

I found your comment and his comment.

Unfortunately, the crankshaft seal is misaligned despite his suggestions. Specifically, I cleaned both the cranshaft and the housing well. I used an ABS pipe and evenly inserted the crankshaft bolt through a hole in the cap of the pipe. I then rotated the crankshaft bolt slowly and evenly.

I'm wondering about using a small diameter wooden dowel to put pressure only on the area still sticking out?

That said, it's off by 2 mm or so. If I can't get it perfectly aligned, what's the risk of a leak?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Crankshaft Oil Seal Misaligned [200][1980]
posted by  1908242DLa  on Tue Jan 15 00:45 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts