Quantcast
RWD - 240 Head Gasket

Volvo RWD Forum

INDEX FOR 1/2019(CURRENT) INDEX FOR 7/2011 [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

240 Head Gasket 1991

I've got everything ready to do my head gasket, new fuel injectors, seals, hushers, timing belt and all the other belts. Do I need to apply gasket sealant at any point or just go straight in with the gaskets? It's already got new plugs and wires, new distributor cap and rotor and I replaced the odometer gear and went through most of the switches and fuses and cleaned them up. Anything else I should do while I'm in it that deep? This is my first post so I hope I'm not beating a dead horse around here....

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Head Gasket [1991]
posted by  TerribleCj  on Wed Jan 2 13:04 CST 2019 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts