Quantcast
RWD - Timing Belt and Crankshaft Pulley in B21F Engine

Volvo RWD 200 Forum

INDEX FOR 7/2019(CURRENT) INDEX FOR 4/2013 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Timing Belt and Crankshaft Pulley in B21F Engine 200 1980

"I notice that the fan has a large, central bolt instead of the 4 studs that connect the fan to the water pump as in the later model 240s."
That's unusual. Check your replacement water pump. Does it have a hole for the center bolt or does it have 4 studs?

"What I don't get is how to remove and correctly torque on reinstall the camshaft bolt."
Did you mean crankshaft? For the crankshaft, just remove the center bolt (7/8"?). I use Lucid's "rope trick" to hold the crankshaft in place. Slide off the gear and remove the semi-circular woodruff key (don't lose it).


--
1980 245 Canadian B21A with SU carb, M46 trans, 3:31 dif, in Brampton, Ont.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Timing Belt and Crankshaft Pulley in B21F Engine [200][1980]
posted by  1908242DLa  on Fri Dec 28 12:26 CST 2018 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts