Quantcast
RWD - Moisture in Trunk (Reprise)

Volvo RWD 200 Forum

INDEX FOR 9/2019(CURRENT) INDEX FOR 9/2014 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Moisture in Trunk (Reprise) 200 1983

Thanks Art. I checked that out. The vents look totally clean/clear with no debris in the hoses. But I set up a rig anyway to put water down in the vent directly. It was a small hose so could not really gush water in there. But I was able to pour about a quart of water in on each side and see water coming out almost immediately on the ground behind the rear wheels. No matter how much I tried to put in, there was not a single drop backing up and falling down into the gully above the trunk lid. It looks to me that these vents really slant down and away so that would make it difficult, I think, for lots of water to get in there unless there was a driving wind pushing it up and in there. Easy enough to check. Cheers!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Moisture in Truck (Reprise) [200][1983]
posted by  whitedavidp  on Sun Dec 23 13:21 CST 2018 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts