Quantcast
RWD - Tailgate handle/latch assembly replacement for 1800ES

Volvo RWD 1800 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 7/2003 1800 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

Tailgate handle/latch assembly replacement for 1800ES 1800 1972

I am in the process of rebuilding the tailgate/latch of my 1800ES with new parts and am having a problem removing the 4-pin ring nut that secures the internal latch assembly to the tailgate handle. So far, I have tried generous applications of PB Blaster and attempting to turn with a snap ring plier without damaging the pin slots, but the ring nut doesn't budge. I think I need a 4-pin spanner nut socket I can use with a socket wrench, but haven't been able to find one with the right size. Here are the dimensions of the ring nut measured with calipers:
O.D. 26.8 mmm
I.D. 3 mm
pin slot width: 2.3 mm

Information on where I can purchase such a 4-pin socket or another way to remove the ring nut would be much appreciated. If I can't get it off, I will have to install the latch assembly in the old handle.

Thanks for reading.


 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tailgate handle/latch assembly replacement for 1800ES [1800][1972]
posted by  guri r  on Sat Nov 3 16:46 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts