Quantcast
RWD - brake rotor minimum thickness

Volvo RWD 120-130 Forum

INDEX FOR 12/2018(CURRENT) INDEX FOR 11/2018 120-130 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

brake rotor minimum thickness 120-130

I'm getting a pulsing vibration when applying the brakes. when I had this problem in the past I checked the front right rotor, and it was either warped - not true, and causing the problem. I turned it down minimally and got it relatively true. I do not know it's current thickness, but may have another one that I can swap, but needs to be cleaned up. I have searched the archives for posts where I recall a discussion stating that the manual's stated minimum could be exceeded by a little bit. I cannot find those posts. I believe Eric had said something to the effect that they were designed super thick and could be turned somewhat smaller than spec. Any info welcome. thanks

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New brake rotor minimum thickness [120-130]
posted by  Danny  on Mon Oct 29 07:40 CST 2018 >
  • New NMI [120-130]
    posted by  james_a_sousa  on Mon Oct 29 09:53 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts