Quantcast
RWD - 1994 940 Turbo -- Installing rebuilt turbo -- how to remove/replace oil line?

Volvo RWD 900 Forum

INDEX FOR 6/2019(CURRENT) INDEX FOR 4/2001 900 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

1994 940 Turbo -- Installing rebuilt turbo -- how to remove/replace oil line? 900

I'm preparing to install a refurbished turbo on a 1994 940. Yes, the brickboard FAQs here are very helpful but I have some questions.

1 -- Regarding replacing the turbo oil supply line -- what exactly is the procedure to get the banjo bolt (19mm?) off the engine block?

The banjo bolt going into the engine block is located right behind the oil cooler sandwich plate / sender unit (OCSPSU). Looks to me that this 19mm banjo bolt is pretty much inaccessible without removal of the said OCSPSU. Is removal of this OCSPSU a big deal -- is it just a matter of removing the 36mm banjo bolt securing it to the block?

Any comments welcome ...






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1994 940 Turbo -- Installing rebuilt turbo -- how to remove/replace oil line? [900]
posted by  rob2volvos  on Sun Oct 21 16:31 CST 2018 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts