Quantcast
RWD - Driveshaft center support replacement

Volvo RWD 900 Forum

INDEX FOR 8/2018(CURRENT) INDEX FOR 2/2018 900 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Driveshaft center support replacement 900

Hello everyone,

I would like to know how to replace the driveshaft center support rubber part only on a 1994 940 Turbo with 90kmi without replacing the bearing. I have read the FAQ and could not figure out how is it done?
I already have the driveshaft out, can i simply slide the rubber support off the bearing, or i need to remove the whole assembly (rubber part and bearing together) using a puller and press the two pieces back in as one piece upon installation?
As always,thank you so much for your help!

Charles

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft center support replacement [900]
posted by  someone claiming to be Charles  on Thu Jan 25 18:37 CST 2018 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts