Quantcast
RWD - Flex Plate Pins

Volvo RWD 900 Forum

INDEX FOR 9/2017(CURRENT) INDEX FOR 12/2000 900 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Flex Plate Pins 900 1994

Doing the rear main seal on my 940 Turbo. Reading the FAQ's and I find reference to Flex Plate (Flywheel) alignment. The FAQ perfectly outlined the procedure, but what are the two (2) riveted pins designed to do?

I understand the 58 key slots in the ring gear and the 2 that are left blank for the crank sensor.

I just do not understand what possible purpose the 2 riveted pins could be used for on the flex plate. Mine are somewhat bent and I do not know if they should be straightened before putting it all back together?

Thanks Everyone!

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Flex Plate Pins [900][1994]
posted by  Townshend Act  on Wed Aug 30 23:33 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts