Quantcast
RWD - M47 output shaft seal replacement

Volvo RWD 200 Forum

INDEX FOR 9/2017(CURRENT) INDEX FOR 2/2011 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

M47 output shaft seal replacement 200

The output shaft seal on my 1993 wagon is leaking. It looks like it can be replaced by removing the output flange, prying out the old seal, and tapping in a new one (similar procedure to rear end pinion seal). However, I read the green book and it looks like they recommend removal of the entire cover plate? Any reason why? Which procedure have you used?

Thanks!

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New M47 output shaft seal replacement [200]
posted by  Adirondack Blues  on Thu Aug 24 07:07 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts