Quantcast
RWD - 92 93 240 A/C Low pressure switch and connector - diagnosing reparing replacing

Volvo RWD 200 Forum

INDEX FOR 6/2017(CURRENT) INDEX FOR 8/2002 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

92 93 240 A/C Low pressure switch and connector - diagnosing reparing replacing 200 1993

So I've got two bricks with almost the same problem - both have either faulty low pressure switches or the connector plug/wiring is the problem. Sometimes the A/C works and sometime it doesn't. Fiddling with the connector (removing/replacing) or bending the wires at the connector will sometimes get the A/C going. Sometimes. Usually works best when first starting up, not when it's warm/hot. And when it's working, the switch/connector/wiring problem usually will cause the A/C system to shut off/on several times a minute, causing the engine to hesitate momentarily as the A/C clutch cycles on/off.
Questions: I assume replacing the switch requires evacuating the system and recharge? Any tips on repairing/replacing the connector and wires? I've tried some electric clean spray and dielectric grease, but that wasn't enough.
Thx in advance BB's!

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 92 93 240 A/C Low pressure switch and connector - diagnosing reparing replacing [200][1993]
posted by  JPistos  on Sun Apr 9 11:18 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts