Quantcast
RWD - How to slide the loose, unclamped tailpipe from the 240GL Wagon, and to disconnect the muffler from its mount.

Volvo RWD 200 Forum

INDEX FOR 5/2017(CURRENT) INDEX FOR 7/2002 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

How to slide the loose, unclamped tailpipe from the 240GL Wagon, and to disconnect the muffler from its mount. 200 1986

You're going to need a very long screwdriver or pry bar for both tasks. Place your pry bar on the rear muffler hanger, passenger side, and just pry it over until you can slide the muffler off of it. Once it is off you can then move the muffler over from driver to passenger side and get it off the other hanger. With the center muffler it get a bit tougher but you will be doing the same thing more or less. Prying the muffler off of the rubber donut. Putting it back is a PIA. IIRC there are 2 hangers. What happens is once you get one on there it makes it tougher to pry the other one on. You will need to find a spot under the car to leverage you pry bar and slide the muffler onto the hanger. If you only get one on there it will hold.GL.

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 How to slide the loose, unclamped tailpipe from the 240GL Wagon, and to disconnect the muffler from its mount. [200][1986]
posted by  XPEG_656  on Sun Mar 19 20:36 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts