Quantcast
RWD - Difficulty replacing front strut cartridges and mounts

Volvo RWD 200 Forum

INDEX FOR 4/2017(CURRENT) INDEX FOR 8/2007 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Difficulty replacing front strut cartridges and mounts 200

Hello all,

Was wondering how difficult it would be to renew the front struts and upper mounts on my 86 240?

Also some boot kits come with and most come without a spacer. Is the spacer required for the job to be done correctly? There's not a whole lot of info to my knowledge on the subject. Just instructables. Is there a step by step procedure?

I'd also be doing by front wheel bearings(inner and outer both sides) as well as a rack. Minas well do it all before alignment. Any and all info would help me greatly.
Geoffrey

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Difficulty replacing front strut cartridges and mounts [200]
posted by  volvoman1980  on Thu Mar 9 23:24 CST 2017 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts