Quantcast
RWD - Front axle assembly removal

Volvo RWD 120-130 Forum

INDEX FOR 7/2019(CURRENT) INDEX FOR 2/2019 120-130 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

Front axle assembly removal 120-130

How can I remove entire front axle assembly, with motor/trans in car?

I've removed one before by hoisting car shell and rolling front assembly out, however, motor was out and on this 122 I prefer to not pull the motor. Front motor mounts attach to axle assembly.

Green book, Clymers, Haynes all give front suspension rebuild info, but with axle left in car.

Any ideas? Lift car and jack up/block motor at same time (it would be tilted to rear? Remove wheels and slide out to reduce lift?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Front axle assembly removal [120-130]
posted by  Amazon66  on Mon Feb 27 13:09 CST 2012 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts