Quantcast
RWD - 27mm Sway bar solution

Volvo RWD 700 Forum

INDEX FOR 4/2019(CURRENT) INDEX FOR 4/2005 700 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

27mm Sway bar solution 700

Hi ya'll , i've been lurking in the shadows and thought i'd share some knowledge on sway bars for the 700/900 series.

I scored an IPD one inch rear bar at the boneyard and after looking for a front one for a year, was a bit disappointed. IPD only sell them as front/rear set, so I wasn't going for the $350+ solution. Fitting the rear IPD bar and upgrading the front to a 23mm 940SE allowed serious over steer!! After some experimentation , I came across this:

Mazda 98 B200 pickup has a 27mm bar which fits with half inch spacer as seen in the photo.
The same year ford ranger will work as well.

I do have the IPD front/rear on my second 740 and it seems like the mazda bar works as good if not better than the front IPD

Hope this helps any one with the one IPD rear bar problem.

Thanks for reading
Alan











THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 2 27mm Sway bar solution [700]
posted by  AlanC  on Wed Aug 18 02:06 CST 2010 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts