Quantcast
RWD - 76 k-jet fuel injection

Volvo RWD 200 Forum

INDEX FOR 10/2019(CURRENT) INDEX FOR 2/2010 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

76 k-jet fuel injection 200

I have managed to break the cold start injector line on a 76 242. Can anyone suggest an appropriate material to replace the hard plasic hose inside the rubber hose? It looks like it is a shrink fit onto barb fittings at either end. According to the material I have found, this thing runs at over 60 psi so I need to make sure it will stay together.

Any/All information would be welcome.

Thanks

Zimm






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 76 k-jet fuel injection [200]
posted by  zimm3  on Tue Dec 23 13:15 CST 2008 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts