Quantcast
RWD - AMM adjustment with test light.

Volvo RWD 700 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 12/2005 700 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

AMM adjustment with test light. 700

Well after realizing my AMM / O2 test light wasn't working due to bad O2 sensor, I replace it. Now adjusting the screw on the AMM to flash, my idle mixture is still rich. If I set the adjustment while running the engine at 2500 rpm and set the AMM screw to where the test light flashes the idle mixture is cleaner and the car runs great. I'm also watching the millivolts from the O2 sensor while doing the run test and all seems to be fine while adjusting the mixture. The BIG question is ? Does setting the AMM mixture screw along with the test light work better at 2500 rpm for setting mixture?
Also Wonder if the engine temp sensor is slowly enriching the mixture ? I do know when the last temp sensor went bad my engine was flooding out. Guess the first thing is to check the temp sensor operating Ohms. or just put the new one in.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New AMM adjustment with test light. [700]
posted by  Swami Ji  on Wed Jul 3 10:58 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts