Quantcast
RWD - in-tank pump/sender assembly - bung nut tool - borrow - near 22207

Volvo RWD 200 Forum

INDEX FOR 9/2019(CURRENT) INDEX FOR 8/2015 200 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

in-tank pump/sender assembly - bung nut tool - borrow - near 22207 200 1988

The bunk nut is not going back on the same way it came off - by hammering into the slots.

The new gasket is obviously thicker. I have lubricated all sliding surfaces of the lock ring and hold downs. I also rigged a squeeze clamp to spread, and using a block, to push down on top of the sender top plate. The bunk nut just bounces off the hold down hooks.

I'm about to take it all apart again and install the original sender seal.

Yes I have the indent on the sender aligned with the tab on the tank.
It looks like ordering bung nut tool will take 2 weeks.

Does anyone in the vicinity of 22207 have a tool to lend?
Does anyone have a way to hack this tool?
- I am looking for a gear puller like Art used. The one I have is too thick to fit in the grooves. ... Maybe I can grind out a wider slot?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New in-tank pump/sender assembly - bung nut tool - borrow - near 22207 [200][1988]
posted by  tbb2  on Wed Mar 6 13:14 CST 2019 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts