Quantcast
RWD - 122 ignition switch removal

Volvo RWD 120-130 Forum

INDEX FOR 8/2019(CURRENT) INDEX FOR 9/2003 120-130 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

122 ignition switch removal 120-130 1967

Hi all--I have the typical ignition switch problem with my 122s, and procrastinated too long to install the push-button starter system. My daughter broke a key off in the switch, and I am unable to remove the broken key. I thought I would remove the switch assembly from the dashboard to get a better look. The service manual says something to the effect of "remove the two screws and remove the switch assembly." I removed the two screws but have not been able to get the chrome ring off the front of the assembly in order to pull it through the dash. Is there some trick? I assumed that it was threaded and would screw off the front, but I've turned it quite a bit without success. Thanks in advance for any help/advice.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 122 ignition switch removal [120-130][1967]
posted by  chrispalmer  on Tue Aug 3 05:28 CST 2010 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts