Quantcast
AWD - Successful Bevel Gear Rebuild

Volvo AWD V70-XC70 Forum

INDEX FOR 7/2019(CURRENT) INDEX FOR 12/2010 V70-XC70 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

Successful Bevel Gear Rebuild V70-XC70 2000

Looked at the 98-99 angle gears, found one with the ratio I need (3.31 to 1) but the case is bigger, about an inch wider, so at a minimum would have to use the 98-99 pass side axle shaft and the driveshaft would be ~1/2 in toward the passenger side. Also the pinion is longer and the driveshaft flange ends up being about 1 1/2 inches further back so would need a different driveshaft length, potentially the 98-99, but I did not investigate. The longer pinion shaft means it will not work in one of the smaller cases so I can't swap the ring and pinion into a newer style case. Installing the bigger case in my 2000 would also require unbolting the exhaust from the manifold.

So now I'm hunting for a 2000 or newer unit with the right gear ratio.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 5 Successful Bevel Gear Rebuild [V70-XC70][1998]
posted by  jadnhm  on Sat Sep 18 16:01 CST 2010 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts