Quantcast
AWD - How to remove/replace rear wheel well cover?

Volvo AWD V70-XC70 Forum

INDEX FOR 5/2019(CURRENT) INDEX FOR 3/2008 V70-XC70 INDEX [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

How to remove/replace rear wheel well cover? V70-XC70 2004

I've been getting P0442s for several weeks (small EVAP leak detected). I went underneath and inspected the fuel tank/EVAP as best I could. I found a hose that enters the fuel tank adjacent to the filler hose is the source of a gunk trail that runs down the side of the tank. It looks like the original crimped hose clamp has gone lazy, letting some vapors escape during the EVAP pressure test.

Getting a new hose clamp in place will not be easy, unless I take off the black plastic wheel well cover.

My question: How do you replace the rivets that tie down the cover to the fender? Do I buy new rivets? Is there a p/n?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How to remove/replace rear wheel well cover? [V70-XC70][2004]
posted by  pbierre  on Sun Dec 30 17:38 CST 2018 >

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts