AWD - ABS module Removal 2006 Volvo V50 non-turbo

Volvo AWD V50 Forum

INDEX FOR 9/2019(CURRENT) INDEX FOR 8/2009 V50 INDEX [<<]  [>>]


ABS module Removal 2006 Volvo V50 non-turbo V50 2006

Help please, ABS module Removal 2006 Volvo V50 Non-Turbo VIN: YV1MW382462165273

Things I can not yet do.

- Remove the wire harness from the firewall. I can not 'free' the lever
- find a recommended company to repair the ABS controller/electronics
- determine screws that hold the hydraulics to the controller and
how to remove all from firewall.
- how do I determine whether I have DTSC on my V50? I think I don't.

I assume the harness connecter resembles the red-orange connector on the
driver side of the air box at the front of the car, that is,
there is a lever which draws in the connector or pushes it out.
I am guessing the lever pivot from the top. It will not budge.

This disconnection is a one-off, due to the 150k+ plus on the car.
I am not against, say damaging the lever and the use of silicone
or mastic to make it stay put when I am done.

As you can see in the photo I have removed the pump. I plan now to
remove the brake lines from the now visible hydraulics part after
emptying the brake fluid reservoir.

Many thanks for reading this. I would be very grateful for any advice.

Mark Barron


New ABS module Removal 2006 Volvo V50 non-turbo [V50][2006]
posted by  mbarron  on Sun Jun 16 07:42 CST 2019 >

Cut and paste link:

<< < > >>

Users marked in green are currently online.

©Jarrod Stenberg 1997-2016. All material except where indicated.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts