http://www.brickboard.com/FORUMS/uid=32586 The Volvo owner's resource since 1997. en Copyright 1997-2009, Jarrod Stenberg Sun, 22 Nov 2009 14:53 GMT Sun, 22 Nov 2009 14:53 GMT brickadmin@denizen.net brickadmin@denizen.net volvo 1440 http://www.brickboard.com/images/logo_b_25.gif http://www.brickboard.com/ 25 25 The Volvo owner's resource since 1997. Fied. stuck pin on the passenger side. the caliper would not slide. thanks for your help.... http://www.brickboard.com/AWD/?id=1385208&rss=1 Mon, 9 Nov 2009 22:30 GMT Yes Brakes,sorry. Pads aren't to bad. I could change them. yes the brake peddle sinks a little on start up. fluid is clean. Maybe a possible anti-lock sensor problem??? thanks for the help... http://www.brickboard.com/AWD/?id=1384015&rss=1 Wed, 4 Nov 2009 02:19 GMT I've got this weird problem with the front breaks. They start to click, very low click, and then are hard to apply. the pads are in pretty good condition. I'm wondering how to go about trouble shooting this thanks for your help.... http://www.brickboard.com/AWD/?id=1383753&rss=1 Tue, 3 Nov 2009 02:57 GMT I found the water leak. After taking Half of thr interior out, I found the water leak coming from the windshield. It's on both sides to. If you hit it just right water poors in. I'll make a appointment at a autoglass place to get it resealed. Thanks for everyone's help with this..... http://www.brickboard.com/AWD/?id=1358696&rss=1 Wed, 8 Jul 2009 15:57 GMT Does the C-70 have trunk drains like my 850 did. I'm hopeing they do thanks for yopur replys. 2000 c-70 hardtop. http://www.brickboard.com/AWD/?id=1358447&rss=1 Mon, 6 Jul 2009 23:38 GMT OK, thank you for your responces. It's not ac condensation there's to much water for that. it starts from the back floor and moves to the front. It's about a gallon. I took the seats out and removed the back pads there's a gallon of water in that one. I need help now becuase I triggered the SRS light. I had one of the seats out and had to move the car. Any help on that also.I will post more findings soon thanks again... http://www.brickboard.com/AWD/?id=1357709&rss=1 Thu, 2 Jul 2009 01:00 GMT I took the carpet up in the front and removed the pad. The pad had so much water in it that it had run down the driveway. The back pad has to come out. I ran the hose under the front of the car no water. I beleive it's comeing from the rear window. Pending...... thank you for your responces. http://www.brickboard.com/AWD/?id=1357006&rss=1 Sun, 28 Jun 2009 12:17 GMT I also have some kind of water leak. The floor on the passenger side to the back seat floor is flooded. It's a hard top no vert, thanks... http://www.brickboard.com/AWD/?id=1355711&rss=1 Sun, 21 Jun 2009 21:12 GMT Klaus sorry for the lack of info,this is my daughters car and I'm trying to fix it while she runs around with it. So it has 93,545 miles, 2.4 turbo I changed it becuase I did a search on the code and this looked like the fix the car runs real good. I used a Bosh replacement and the car uses 87 octane. The light stayed off for a while and came back on again. I scan'd it and now I have a PO456. I reset the code and lets see if it returns. I'm going to start to change some small vaccume hoses. ??? pending http://www.brickboard.com/AWD/?id=1347317&rss=1 Mon, 4 May 2009 16:29 GMT Iv'e had this problem for awhile now it's giving me a real tough time .so far there's no vac leaks car runs good I changed out the rear o2 censor any thoughts would be helpful thanks.. http://www.brickboard.com/AWD/?id=1347155&rss=1 Sun, 3 May 2009 15:33 GMT For a 2000 2.4 turbo. I know this is a bad post but I need the info thanks......... http://www.brickboard.com/AWD/?id=1342635&rss=1 Wed, 8 Apr 2009 18:03 GMT Thanks for the Info, It's sounds like a wind leak between the glass and the door rubber. I will try to adjust the door contact points and give that a try. http://www.brickboard.com/AWD/?id=1337326&rss=1 Thu, 12 Mar 2009 21:08 GMT I have a lot of wind noise whenthe drivers side window is up.I looked at the window rubber and it runs around the whole door, anybody do this before. thanks..... http://www.brickboard.com/AWD/?id=1337063&rss=1 Wed, 11 Mar 2009 16:31 GMT Same thing as my 95 850. Out of the top with the fluid. I thought it might have been out of the bottom thanks........... http://www.brickboard.com/AWD/?id=1329422&rss=1 Mon, 2 Feb 2009 16:14 GMT On a 2000 c70 is it the same procedure for a tranny flush as my 95 850. Tranny fluid flows from the top hose out??? thanks for the reply........ http://www.brickboard.com/AWD/?id=1328683&rss=1 Fri, 30 Jan 2009 03:14 GMT Ok I want to flush the tranny on my 2000 c70 2.4. On my 95 850 the top tranny hose by the radiator had metal clip this one has green plastic clips. Is it the same method on a 2000, take the top hose off go into a jug about 3qts and refill and repeat. Squeeze the green clip in and pull out. thanks for the help ...... http://www.brickboard.com/AWD/?id=1328676&rss=1 Fri, 30 Jan 2009 02:47 GMT I found it. I washed the motor down with gunk and got it nice and clean. I drove it around for half the day running erands and It's coming from behind the crank pully. From looking under there I can see that there's been a build up of some oil for a while. I now have to look into the repair for this .I want to thank everybody for there time and help. JOE...... http://www.brickboard.com/AWD/?id=1314516&rss=1 Mon, 17 Nov 2008 15:13 GMT I put the car on a lift and took another look. The only thing I can tell is the oil leak is coming from behind the timeing case cover. I don't know whats behind that cover that can be leaking..... JOE.. http://www.brickboard.com/AWD/?id=1314230&rss=1 Sat, 15 Nov 2008 15:17 GMT Thanks for the help guys. The leak is not coming from the top of the motor. The four seals are dry around the cams and dist. I have to check for oil cooler lines I don't think I have that option. Could this be a possible oil pump problem???? I look under the car the top of the motor is dry I look at the back of the motor on top with a mirror and it's wet from the water pump down. Thanks for yoour replys......... http://www.brickboard.com/AWD/?id=1313987&rss=1 Thu, 13 Nov 2008 16:42 GMT I did a search on this and found something close. I have a big oil leak just behind the water pump. (850 2.4 5cyl.) It looks like it's slinging it around. it's not just a drip... I found in the search it could be the OIL PUMP,or the two halfs of where the head meets the block. No leak from the water pump or the timing seals both are dry... Thank for the help......... http://www.brickboard.com/AWD/?id=1313773&rss=1 Wed, 12 Nov 2008 17:55 GMT Thanks Klaus I'll look into it. http://www.brickboard.com/AWD/?id=1309082&rss=1 Tue, 21 Oct 2008 14:39 GMT Is this a EVAP problem or a o2 sensor problem. Check engine light came on and set a code 95 850 thanks for your help........... http://www.brickboard.com/AWD/?id=1308594&rss=1 Sat, 18 Oct 2008 21:30 GMT Join the online help site called Alldata. for the small amout your gonna pay it's worth it. you can talk to a machanic and go through a step by step process and you will learn something and get your car fixed....... good luck. http://www.brickboard.com/AWD/?id=1285379&rss=1 Tue, 24 Jun 2008 18:27 GMT Thank you klaus I'll give it a shot. JOE http://www.brickboard.com/AWD/?id=1275044&rss=1 Sat, 3 May 2008 16:18 GMT Guy's Iv'e' tried everything new lower control arms with new Ball joints. New tie rod end new struts. The right front wears the outside of the tire first. I had a wheel aligment done and they say there's no camber problem. I'm getting tired of buying tires Thanks for your help JOE............ http://www.brickboard.com/AWD/?id=1274105&rss=1 Mon, 28 Apr 2008 14:59 GMT Use the text input below to search brickboard.com query http://www.brickboard.com/FIND/