V8 - 130 AMP alternator

Volvo V8 Forum

INDEX FOR 4/2014(CURRENT) INDEX FOR 1/2012 INDEX (NO RELOAD) [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE   A    A 

130 AMP alternator

Hello all-

'93 940 wagon. Engine: Ford 5.0

Sadly, the original owner/builder passed away a few years ago and I have become a very grateful caretaker of this marvelous car. I have truly done my best to keep it in the best of shape but unfortunately never had the background of the original build required to do "Mods to the Mod."

Situation: The front bearing has failed on the 2G alternator. This setup had only 1 lead on the B+ output side.
Bought a PA Performance 3G alternator. It is installed with fused 2Ga leads to the battery.
RJM Injection Tech 3G Alternator harness is used to complete the installation.
All pretty straight forward to this point. Except for one 12 volt lead...

Peter- The green wire on the new 3G harness needs a 12 VDC source with the ignition switch in the "run" position.
Can you help me with the location/wire color to be used for my source (Back side of the IGN SW?).

Thanks for any help provided.

Jeff

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 130 AMP alternator
posted by  jgk  on Thu Jan 26 23:49 CST 2012 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2012. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts