RWD - front wheel bearing- DIY?
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 10/2003 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

front wheel bearing- DIY? 200 1978

Bought my '78 244 with a slight vibration & disconcerting "whuppawhuppa" noise in the front end. Seller said "I dunno, I think the front brakes are gone." I investigated & found the pass. caliper had a blown piston seal. I had recently had the same failure on my '84, so no problem. (OF COURSE they weren't the same caliper...)

Anyway, that wasn't it; it later became obvious the bearing was smoked. I've done outer bearings before, easy enough, but I've heard that inner bearings on these need to be "pressed in". Can I do this in my yard? If so, what tools will I need?

Thanks,
Matt
1978 244 (Katharine)
1984 244 (Gretchen, RIP)




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New front wheel bearing- DIY? [200][1978]
posted by  MSW  on Wed Oct 29 12:04 CST 2003 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts