RWD - Wagon rear bumper overider

Volvo RWD 120-130 Forum

INDEX FOR 3/2010(CURRENT) INDEX FOR 11/2009 120-130 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

Wagon rear bumper overider 120-130 1967

Someone in the past hit the RR bumber overider, with the rubber top, and managed to bend it. It now rattles a lot and is loose. My intent is to pound it out so that at least the sides are straight and it no longer rattles with every bump.

I sprayed PBBlaster into the overider but to no avail. It appears to be rock solid. I don't want to destroy this nice piece of chrome with over-torquing. Is there something I should be doing differently? Removing the whole bumper seems over kill and I will still have this rusty bolt problem. Besides, it seems it is full of leaves,twigs,dirt,etc.

Klaus
--
Proud owner of a 220S. If I had more room, I would have more Volvos.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Wagon rear bumper overider [120-130][1967]
posted by  KlausC  on Wed Nov 18 13:16 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts