RWD - I'm told my outer tie-rod is bad, but at 3 & 9....

Volvo RWD 200 Forum

INDEX FOR 3/2010(CURRENT) INDEX FOR 11/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

I'm told my outer tie-rod is bad, but at 3 & 9.... 200

I'm not sure how they said you have Loose Wheel Bearing nuts AND a tie rod issue.
If there was side to side movement at 3 and 9 it could be one issue or the other or both.. but you would have to fix one and come back and retest to verify additional issues.

On tire off the ground at a time to check Ball joints. I would use a Floor jack under the 'A" arm so the suspension stays 'loaded' to get an accurate reading as to what's going on...if anything.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New I'm told my outer tie-rod is bad, but at 3 & 9.... [200]
posted by  transit wind  on Wed Nov 18 00:16 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts