RWD - Problem unscrewing AC fitting

Volvo RWD Forum

INDEX FOR 3/2010(CURRENT) INDEX FOR 11/2009 INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

Problem unscrewing AC fitting

It's a '89 240, I have a '90 245 with the same AC Compressor.
I soaked it with PBlaster and tapped on it endlessly and it doesn't budge.
If I use any more force it is going to gouge and distort the fitting.
It is just a typical looking flare fitting but the nut is totally stuck; it looks like soft metal that is going to get ruined if I keep messing with it.

I got the hose disconnected from the compressor but I had to twist it into knots until the flare cleared the threads. I'll have to turn the entire hose to thread it back on & I probably screwed up the metal interior of the hose by forcing it into extremely ungentle curves.

I was curious if anyone else has hit this unexpected snag.

Even off the car, the flare fitting doesn't want to give.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Problem unscrewing AC fitting
posted by  Bryan.C  on Fri Nov 6 13:20 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts