RWD - Engine and tranny mounts

Volvo RWD 120-130 Forum

INDEX FOR 3/2010(CURRENT) INDEX FOR 11/2009 120-130 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

Engine and tranny mounts 120-130 1967

Hello,

Do not be surprised if you have to shorten 1 of the 2 studs for the transmission mount.

Most of the transmission mounts have studs that are too long and this will interfere with the back of the transmission when you go to bolt it back onto the transmission.

When installing transmission mounts on M41s in 122s, I also usually have to install 3 to 4 thick fender washers between the transmission mount and the transmission cross member to space the transmission up high enough so it will not hit the cross member on large bumps.

--
Eric
Hi Performance Automotive Service (formerly OVO or Old Volvos Only)
Torrance, CA 90502




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Engine and tranny mounts [120-130][1967]
posted by  KlausC  on Thu Nov 5 16:09 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts