RWD - Replace one-wire O2 sensor with heated sensor?

Volvo RWD 200 Forum

INDEX FOR 3/2010(CURRENT) INDEX FOR 9/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

Replace one-wire O2 sensor with heated sensor? 200 1984

Me thinks it's time to replace my O2 sensor. Mine is a one-wire sensor. Would it make any sense to install a three-wire sensor assuming that it will send more accurate readings sooner than an unheated one? How would the two-wires for the heater be installed? Would it confuse the ECU or are the sensors the same other than the heater?
--
Mike F - 1984 244 DL - 285,000 miles
Original engine, transmission, drive train, starter
Undergoing reconstructive surgery with POR-15




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Replace one-wire O2 sensor with heated sensor? [200][1984]
posted by  Lord Volvo  on Mon Sep 28 11:37 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts