RWD - Crank Position Sensor Bracket
                    

Volvo RWD 700 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 700 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

Crank Position Sensor Bracket 700

Ryan,

Drill and a dremel worked fine. Tried to pull tranny out but got stuck on one pesky bolt. So I had to abort, and went for a drill. Was done in 2 hours and back on the road today. I only had to trim about half an inch on each side.

Thank you




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Crank Position Sensor Bracket [700]
posted by  R.S.  on Sun Jun 28 18:52 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts