RWD - FI Fuel lines
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

FI Fuel lines 200 1979

Hi there,

I have to make the leap from my 4-cyl to assume your lines are the same. I've looked at sixes in the yards before, so I'm pretty certain the fuel distributor is plumbed with the same fittings for the most part.

The lines are rubber covered nylon. I've been lucky enough to get what I need at the boneyards, because, unlike the other nylon fuel lines Volvo uses, I haven't been able to find off-the-shelf stock for the 2.4mm ID / 6mm OD nylon used under the hood in the K-jets. Closest I see is .093 Nylon 11 sold by McMaster-Carr, but its wall thickness is only 30% that of the original.

I've never heard of anyone replacing these lines with 30R9 neoprene, but the ID to fit the barb would be 3/32".
--
Art Benstein near Baltimore

Wear short sleeves! Support your right to bare arms!




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New FI Fuel lines [200][1979]
posted by  fishsqueezer  on Thu Jul 2 13:10 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts