RWD - gear box brass plug and clutch
                    

Volvo RWD 700 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 700 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

gear box brass plug and clutch 700 1987

Goatman,

Thanks. I also tried large channellocks, but that didn't work either.

Why a 19 mm six point box end wrench? I used a 13 mm 12 point box end wrench.

At this point, the nut is so chewed up, no wrench will probably work. I'll try again with the chanellocks in the near future. If that doesn't work, I think that maybe I can drill two holes opposite each other and use an old bicycle bottom bracket remover, which has two prongs.

Worst case scenario is drilling and chiseling the brass plug out.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New gear box brass plug and clutch [700][1987]
posted by  fredbyte  on Thu Jul 2 18:59 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts