RWD - M410 bellhousing clutch bracket??
                    

Volvo RWD 140-160 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 140-160 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

M410 bellhousing clutch bracket?? 140-160

At the risk of completely screwing things up for you, have you measured the bellhousing to make
sure it is the right size for your engine?
If your bellhousing is set up for a slave cylinder rather than a cable, it may not fit your engine, either.
Measure and make sure before you tear a bunch stuff down!
I can provide measurements for both b18/B20 bellhousings and also B30.
They are about an inch different.
--
George Downs, Bartlesville, Heart of the USA!




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
M410 bellhousing clutch bracket?? [140-160]
posted by  aaron74  on Wed Jul 1 17:58 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts