RWD - 240 Rotor Identification
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

240 Rotor Identification 200

I considered that, but as part of this whole front end re-doux I replaced the front bearings so I know they are installed correctly. I first noticed this situation about six months ago. I upgraded our '83 coupe to vented front discs. One of the reasons for doing this was because I knew I had discs on hand and picked up a set of clean calipers from a friend for a song. Surprise! Had to go out and buy discs. Thus my query about others' experiences, and hopefully measurments, on cars earlier than 86. The discs on the '83 measure 1 13/16 hat height too, I just stuck my tape measure through the alloys and measured. I'm starting to think I should move this post over to the 140-160 forum and see if I can get some input there. No word from Brembo yet.

Thanks Phil,
DS




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 240 Rotor Identification [200]
posted by  David Samuels  on Tue Jun 30 11:35 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts