RWD - 240 Rotor Identification
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 7/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

240 Rotor Identification 200

I'm just curious too!

By any chance, could it be the your outer race of the bearings are not seated all the way into the disk? The rear bearing would cause it to set out too far. You only need half of that back to be centered.

Phil




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 240 Rotor Identification [200]
posted by  David Samuels  on Tue Jun 30 11:35 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts