RWD - Too lean ...
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 6/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

Too lean ... 200 1993

Sounds like your brake check valve or hose to and from the servo. I recently replaced one. If the check valve looks good it could also be the rubber seal around it. Both the check valve and seal where cracked on mine. It didn't solve my stall problem but it helped some. The servo can also go bad but not as common from what I've read.

My car didn't pass last time because my cap had a spring thing at top inside that broke and the plastic was melting around where it received that volt.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Too lean ... [200][1993]
posted by  leugim  on Sat Jun 20 13:32 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts