RWD - OKAY SO I GOT INTO AN ACCIDENT and I need to "straighten' some things out
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 5/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

OKAY SO I GOT INTO AN ACCIDENT and I need to "straighten' some things out 200

My car was wrecked and repaired before i got it. The hood was just a little bent and they did not replace it. When I tried to realign it to make it fit better the latch pin hooked on the radiator support and would not open.

Remove the little splash shield between the bumper and the bottom of the radiator support. Pry or whack the latch pin so that it goes back to the center of the hole. You might have to have someone pull on the release cable to get it out.

Greg




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 18446744073709551615 OKAY SO I GOT INTO AN ACCIDENT and I need to &quot;straighten' some things out [200]
posted by  geodonuts  on Wed May 13 14:10 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts