RWD - Before I order - LAST hall sender question
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 5/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

Before I order - LAST hall sender question 200 1983

I have determined (fingers crossed) at long last that my intermittant run problem stems from a faulty hall sender (impulse sensor). My '83 falls into that funky and short-lived period when several distributor components were used. It has the Bosch unit with the round plug at the end of 5" of pigtail.

I want to convert to the hall sender with the rectangular plug used on the '84 because the original round plug unit runs around $290.00 (AC/Delco E1944C), while I can get the '84 rectangular plug hall sender for about $110.00 (Volvo PN 1237031166).

Even though both of these run with the same ICU (1317295), a mechanic very convincingly told me today that if I splice on the rectangular plug and use the '84 sender, I will risk frying the ICU because the "resistance values" from one to the other will be different. I don't get it. Who's out to lunch on this one, me or him?




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New Before I order - LAST hall sender question [200][1983]
posted by  jimo14  on Sat May 9 19:45 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts