RWD - Oil Separator Box
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 4/2009 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

Oil Separator Box 200 1993

Hello Fred,

I remove the throttle body and IAC along with the AMM and intake plumbing. You really don't have to touch the intake manifold.

Then removed the harness wrap-around which screws to the top of the box. You can deftly push the harness up then lift the box up til it's bottom protrusions clear the block and get it out.

I clean up the block mating surfaces and on reinstallation, I make sure I have a new O-ring ($3 part from Volvo!) and use some non hardening seal at the front hole.

Marty Wolfson




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 4 Oil Separator Box [200][1993]
posted by  Oleseahorse  on Fri Apr 10 18:18 CST 2009 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts