RWD - Failure sensing the three Brake Light bulbs
Try the improved search:                   

Volvo RWD 200 Forum

INDEX FOR 11/2008(CURRENT) INDEX FOR 7/2008 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

Failure sensing the three Brake Light bulbs 200 1989

"While the top mount brake light does run through the sensor, I'm not sure if it is part of the bulb out sensing system."


As you know, the basic BFS principle is that an equal current thru two opposing coils (having the same number of turns) will cancel each other, and thus have no effect on the reed switch inside the coils, which grounds the Warning light.

The 3-Light Brake Light test circuit is similar, except that the Left bulb is tested by one coil (say a nominal 20 turns), which is opposed by two coils end-to-end, nominally 10 turns for the Right bulb and 10 turns for the High Stop bulb.

As long as all three bulbs work, the 20t coil and 2 x 10t coils cancel out. However, a failure of any one of the three bulbs will upset the 20:20 "magnetic balance" and the reed switch will light the BF Warning light.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 1 Tail lights work but I get the bulb failure light [200][1989]
posted by  Justin A  on Tue Jul 29 13:51 CST 2008 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts