RWD - 740 Turbo Filter Adapter and Thermostat Oil Seals
                    

Volvo RWD 700 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 4/2005 700 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY Replies to this message will be emailed.    PRINT   SAVE   A    A 

740 Turbo Filter Adapter and Thermostat Oil Seals 700

I understand it may be possible to re-new the O-Ring oil seals on the oil filter adapter to block and thermostat (Oil Cooler) housing from below without removing the Turbo/Manifold etc.

However its a pig of a job and may require some other parts dismanling?
before doing the job.

Has anybody done the job? and what problems did you encounter?

My filter adapter not only the large bolt to the block at the front but a smaller bolt on a little bracket to steady it further back which I assume also needs to be removed?

I've looked at the FAQs and found some info, but any further information or advice, particulary first hand knowledge would really be appreciated.

I only have have trolley jack, ramps etc no lift or pit.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New 740 Turbo Filter Adapter and Thermostat Oil Seals [700]
posted by  Colin_D  on Mon Apr 4 14:08 CST 2005 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts