RWD - VX CAM install running rough.

Volvo RWD 200 Forum

INDEX FOR 4/2014(CURRENT) INDEX FOR 2/2012 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE   A    A 

VX CAM install running rough. 200 1989

Hello, all... I just installed a new VX cam from IPD, and their new adjustable cam gear. It is running rough at first, when I first start it, but within a minute or two, it smooths out considerably... but still has a bit more vibration than I would like... I was thinking my timing with the distributor may be a tooth off, so I was going to try to adjust it once the weather warms up a little, but I was also wondering, since it settles down a bit, if it may be the fact that I did not reshim my valves...? If so, should I continue to run with the new cam, or switch back?
--
1989 244 DL first Volvo

 





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New VX CAM install running rough. [200][1989]
posted by  volvoboy89  on Sat Feb 11 12:08 CST 2012 >

[about brickboard ads]

Cut and paste link:

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2012. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts