Volvo RWD 200 Forum
INDEX FOR 11/2009(CURRENT)
INDEX FOR 4/2008
200 INDEX
INDEX (NO RELOAD)
[<<]
[>>]
posted by
transit wind
on
Tue Apr 1 15:53 CST 2008
Author:
[PROFILE]
[EVERY POST]
[THREADS]
[BEST POSTS]
[IGNORE ALL POSTS]
last visit: Thu Nov 19 03:43 CST 2009
[RELATED]
|
|
I replaced the white capped distributor with a bosch from a donor with the same year. I spliced the connector to the hall sender. First I couldn't get a reading from thye A contact (according to Bentley) on the plug. I pulled at the wires a little and found one came loose. I fixed it and got a reading on contact A. I then took out the #1 cylinder spark plug and hooked it up again to its wire. I taped it to the top of my valve cover so it touched the oil filler rise. I got no spark when trying to start the car. I then jumped B to C contacts on the plug. I didn't get a spark but rather a sound like the fuel pumps turned on briefly and a short buzzing sound coming from the engine block.
I used the splicing connectors that you crimp. Maybe I should try soldering the splices. Any one every run into this problem.
|
Select, copy to buffer, and paste anywhere:
|
[about brickboard ads]
|
Users marked in green are currently online.
©Jarrod Stenberg 1997-2007. All material except where indicated.
Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.
Replaced distributor & spliced connector/ no start [200]