RWD - No heat after new WP, thermostat, hoses, radiator flush.
                    

Volvo RWD 200 Forum

INDEX FOR 11/2009(CURRENT) INDEX FOR 3/2008 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

No heat after new WP, thermostat, hoses, radiator flush. 200 1993

OK little mystery here: Whilst changing the timing belt, I also put on a new water pump, changed radiator hoses, heater hoses (that was fun), put in a new thermostat. So then I flushed the radiator, like the directions say on the flush: "Run car to normal operating temp, put heater on high, run for 10 more minutes.." But there was no heat coming out the vents. I checked the radiator hoses - they were hot and full of water, the supply heater hose was also hot.
Any ideas? Thanks.




Select, copy to buffer, and paste anywhere:


[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New No heat after new WP, thermostat, hoses, radiator flush. [200][1993]
posted by  someone claiming to be jpistos  on Sun Mar 30 05:04 CST 2008 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts