RWD - drawtite modulite trailer hitch lights setup
Try the improved search:                   

Volvo RWD 200 Forum

INDEX FOR 10/2008(CURRENT) INDEX FOR 9/2005 200 INDEX INDEX (NO RELOAD) [<<]  [>>]

 VIEW    READ ONLY    PRINT   SAVE   A    A 

drawtite modulite trailer hitch lights setup 200

Ocean,

Running power leads from the battery to the rear, is pretty simple, I've supplied power to rear SubW amps in both my 244Ti and 745T. The longest part of the run is a piece of cake, from just before the fire wall to rear cargo/trunk. Remove (gently pry up)the plastic threshold caps on the driver's side door frames and simply run the wire along the edge of the carpet and snap the covers back in place. I install a 25 amp water proof inline fuse/holder near the positive connection at the battery. Use an exisiting wire passage to run the new wire through the firewall into the engine bay. In all a 10 to 20 minute, relatively simple procedure.





[about brickboard ads]

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD
New drawtite modulite trailer hitch lights setup [200]
posted by  oceanre  on Sun Sep 18 13:55 CST 2005 >


[about brickboard ads]

<< < > >>


Users marked in green are currently online.

©Jarrod Stenberg 1997-2007. All material except where indicated.


Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.

All participants agree to these terms.
Powered by Denizen - Custom Software for Enthusiasts